1001 Typical Details - Standard CIP construction, depths of layers dependant on loadings/vehicle movements.
1002 Manhole - Detail of hanching to manhole or gully. Haunch to manhole to be kept 75mm below finished level and continuous to avoid grout ingress.
1003 Overlay on concrete - Overlay on concrete. Plane out existing concrete to required depth lay Open Graded Asphalt and apply mortar,saw cut joint and seal.
1004 Full Depth Construction - Full depth reconstruction, break out existing concrete,lay base coarse, lay Open Graded Asphalt and apply mortar, saw cut joint and seal.
1005 External Interface - Detail of interface with a building or other obstruction. To enable the surface of the system to be finished and compacted a formed edge should be provided.
1006 UHPC- Concrete - At the junction of a new flexible CIP construction and an existing concrete slab a flexible joint should be installed.
1007 Internal wall - Internal floors can be laid prior to partitions being installed and then fixed to the floor using expanding bolts or other propriety fixings and the fixed to the partition.
1008 Holding Down - Shelving can be fixed to a CIP internal installation by post drilling and fixed down using chemical anchors.
1009 Drainage Channel - At the junction of a Grouted Macadam surface and a drainage channel to a avoid cracking a flexible joint can be introduced by saw cutting after construction and filling with a flexible joint filler.
1010 Junc Int-Ext - At the junction of a building and an external installation the external construction should be kept separate from the building.
1011 Block Paving - Grouted Macadam - Detail showing junction between a slab/block paving and a CIP installation. If the Grouted Macadam surface is installed first a fixed edge must be provided at the junction.
| 2